Packing Cutter

Packing Cutter with 45º Cutting Angle

The use of a packing cutter facilitates the cutting of packing rings directly from the spool without any waste of material.

Advantages:

  • easy to use
  • precise cutting of packing rings
  • always handy
  • close fitting joints

  • Directions for use:

    Clamping down of packing cutter reduces risk of injuries!
    Adjust packing cutter to correct shaft diameter and packing cross section: align the cross-section-index of the cross- section-slide with the index of the shaft diameter on the scale of the cutter. This way the necessary additional length is assured.
    If you want to cut without any additional length, then you have to align the "O" of the cross-section-index with the shaft diameter plus cross section of the packing on the scale of the cutter.
    Pull the packing from the spool (the end needs to have a 45° cut). Align this end with the 45° backstop of the slide and press the natural curvature of the packing flat onto surface of cutter. This is important for correct cutting and forming of ring!
    Affix packing with clamp, then cut.
    IMPORTANT: check the length of the first packing ring on the shaft (cut ends must meet, inner diameter of packing ring should be slightly bigger than shaft).
    If found satisfactory, cut as many rings as you need. If not, re- adjust and check again.

     

    Protetor de Flange
    Packing Cutter Ruler

     

     

     

    TEADIT® Deutschland GmbH

    Schanzenstraße 35, 51063 Köln, Germany

    Phone: +49 (0)221/922 342-0

    Fax: +49 (0)221/922 342-22

    TEADIT® International Produktions GmbH

    Rosenheimer Str. 10, A-6330 Kufstein Austria

    Phone: +43-5372-64020-0

    Fax: +43-5372-64020-20

     

    2016 © Teadit | All Material Copyright are reserved.

     

    This website uses modern technologies such as JavaScript, CSS, HTML5 and WebFonts; because of this, it is best viewed in modern browsers.

    We recommend to use Google Chrome as your primary browser for this website.